Ronseal Decking Stain is a hardwearing, scuff resistant formula that colours and protects to provide a tough and durable natural finish. It resists cracking, peeling and blistering and withstands foot traffic. Rain proof in 90mins so your deck's back in action in no time.

Ideal for colouring and protecting all hardwood and softwood decks.

Two coats are recommended.

Areas of use: Hardwood and soft wood decking.
Approx coverage: 12 m2 covered per litre.
Approx number of coats: 2.
Finish: Semi Translucent Matt.
Application: Brush.
Drying time approx: 90 mins.
Protection level: High.

COVERAGE
A 2.5 litre pack is normally sufficient to coat;

Rough sawn boards two coats ~ 10-15 square metres.
Smooth planed boards two coats ~ 15-20 square metres.

Two coats are recommended. Coverage may be reduced on deeply profiled boards.

PREPARATION

Old decking: Use Ronseal Decking Cleaner and Reviver to remove any dust, grease, oil, mildew, algae and other contaminants. Remove any loose, flaking or peeling coatings. For best results and to avoid patchiness remove all previous coatings. Ensure the ends are adequately protected using Ronseal Decking End Grain Preserver.
New wood: New decking timber should be allowed to weather naturally (usually 6 months) to ensure any pre-treatment has sufficiently eroded, allowing penetration and adhesion of the stain. Clean the decking with Ronseal Decking Cleaner and Reviver, using a scrubbing brush to open the pores of the wood and remove any contamination from the manufacture of the decking. Then rinse thoroughly with cold water, ideally using a pressure washer and allow to dry completely before overcoating. Test effectiveness of cleaning by splashing the deck with water, if beading occurs, re-clean. Retest prior to applying Decking Stain.

APPLICATION

Ensure decking is thoroughly dry. Do not apply in damp conditions or when rain is likely before product has dried. Do not apply below 10 degrees C.
Stir thoroughly before and during use. Do not dilute.
Use a good quality wide brush designed for the application of water based finishes. Apply liberally to ensure that even penetration and complete coverage of the decking is achieved. Ensure the leading edge is distributed evenly. Always work along the grain.
When applying to deck boards, treat 3-4 boards at a time to avoid overlap marks.
We recommend 2 coats, however, to achieve a deeper colour you can apply a third coat. For maximum protection apply to all sides and ends of the decking.

CLEAN UP

Remove as much decking stain as possible from brushes before cleaning. Clean brushes with water and detergent. Do not empty into drains or watercourses. Some local authorities have special facilities for the disposal of waste coatings.

MAINTENANCE

Decking treated with Ronseal Decking Stain can be cleaned using Ronseal Decking Cleaner and Reviver. Inspect the coating on an annual basis and re-coat when necessary.

2.5 Litre Charcoal Ronseal Decking Stain